Revo REVDN700E-2 Manuel d'instructions télécharger pdf (Page 10)

INSTALLATION – VP DOME

1. Loosen the four torx screws located midway up the front of the housing leaving the

screws intact in the front portion. (Fig. 1)

2. Drill the mounting location, using the Drilling guide. (Fig. 3)

3. Attach the housing to the ceiling using suitable fasteners, M6x35 tapping screws are

supplied. Only use if they are suitable. (Fig. 3)

4. Close the housing using the loosen torx screws. (Fig. 2)

Torx screws

(

)

Seal around

the housing

base tightly

using

Figure 1

Figure 2

*Label is attached at the bottom.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Pas de commentaire

Revo REVDN700E-2 Manuel d'instructions Page 10