Revo REP3DC12-8-10 Manuel d'installation télécharger pdf

• 12VDC output.

• Eight (8) individually fuse protected, power

limited class 2 outputs.

• 10 Amps total continuous supply current.

• Filtered and electronically regulated outputs.

• Surge protection.

• Output fuses are rated at 3 Amps.

• Main fuse is rated at 10 Amps.

• AC input and DC output LED indicators.

• Spare fuses included.

Installation Instructions:

CCTV CAMERA & ACCESSORY POWER SUPPLY REP3DC12-8-10

Primary:

• Input 115VAC 60Hz, 2.5 Amps

Outputs:

1. Mount the REP3DC12-8-10 in desired location.

2. Connect green lead to earth ground. Connect AC (115VAC 60Hz) to the black and white

leads of the transformer. Use knockout adjacent to the transformer 1/4” spacing must be

provided between AC input wiring and all other circuits.

3. Adjust output voltage using trim pot on the board prior to connecting CCTV devices.

4. Connect each DC CCTV cameras to terminal pairs marked [+ thru -] on P3DB-4 board

carefully observing correct polarity.

NOTE: It is important to measure output voltage before connecting devices. This helps

avoid potential damage. Terminals marked [+] are positive and terminals marked [-]

are negative.

5. Green LED will illuminate when unit is powered.

6. Upon completion of wiring, secure enclosure door with catch.

WARNING:

• To reduce the risk of fire or electric shock do not expose this unit to rain or

moisture. This installation should be made by qualified service personnel and

should conform to all local codes and in accordance with the National Electrical

Codes. For continuous protection against hazard, replace only with same type and

rating of fuse.

• The power cord included with this power supply is intended for temporary testing

purposes only.

• Before testing, ensure that the enclosure has been properly grounded as per local

and National Electrical Codes.

• This product must be installed by qualified personnel in accordance with all local

and National Electrical Codes.

P31002-11/05

Résumé du contenu

Page 1 - Outputs:

• 12VDC output. • Eight (8) individually fuse protected, power limited class 2 outputs. • 10 Amps total continuous supply current. • Filtered a

Commentaires sur ces manuels

Pas de commentaire

Revo REP3DC12-8-10 Manuel d'installation

Naviguer en ligne ou télécharger Manuel d'installation pour Adaptateurs et onduleurs de puissance Revo REP3DC12-8-10. Revo REP3DC12-8-10 Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels